A clean, flush doorway begins with a coordinated set of measurements. Use this checklist to prepare your rough opening, wall details and door schedule before requesting an Equinox Jambs quote.
For architects, builders and homeowners planning Zero-Edge interior doors.
The leaf that moves.
The complete jamb assembly.
The space prepared in the framing.
These are different dimensions. Confirm each one on the approved drawing.
There is no single rough-opening allowance that works for every trimless door. Start with the selected jamb system and its approved size chart, then confirm the required framing dimensions for your door configuration. A nominal door size alone is not enough to set out the opening.
Equinox Zero-Edge drawings distinguish panel size, net frame size and rough opening. Review the Zero-Edge catalog and size chart with your project team before framing or ordering. Allowances from another brand or frame profile should not be transferred to this system.
Record the specified door width, height and thickness. State whether the opening uses one leaf or a pair. Keep the panel dimensions separate from the frame dimensions in your door schedule.
Use the complete frame dimensions shown for the selected configuration. Check that the door panel, jamb profile and hardware preparation belong to the same approved assembly.
Confirm the structural opening required around that frame. Have the installer verify site conditions against the approved drawing before any framing is finalized.
Give every doorway an opening reference, such as D01 or D02. Use that reference on drawings, photos and your door schedule so dimensions and hardware details remain connected to the correct room.
Record the opening width at the top, middle and bottom, and the height at both sides. Note any differences rather than averaging them away. Ask the installer to check plumb, level and squareness; a larger measurement does not correct an opening that is out of alignment.
Include the complete wall build-up, not just the stud depth. Identify drywall layers and any additional finishes around the doorway. If the finish differs on each side, show both conditions on a simple section sketch for review.
State whether the height was measured from the subfloor or the finished floor. Share the planned flooring build-up and changes between rooms. Confirm the required bottom clearance with the project team instead of assuming a standard gap.
Show the direction the door opens, the hinge side and the wall face intended to align with the door. Include a plan sketch from a stated viewing direction. This is clearer than relying on a left-hand or right-hand label alone.
Identify the door thickness, selected hinges, latch or lock and handle requirements. Check their compatibility and preparation before ordering. Explore the hinge options and door handles with the selected frame and door panel.
Say whether the opening is being designed, framed or already finished. Share site photos for existing walls. For Zero-Edge work, coordinate the jamb and wall finish early; our before-drywall planning guide explains the sequencing questions to resolve.
Prepare one entry for each opening. If a detail has not been decided, mark it “to be confirmed” so it can be reviewed before manufacture.
Record measurements consistently in the units used on your drawings. Keep original site notes and label any dimensions that still need verification.
Zero-Edge aluminum jambs support a trimless, flush-to-wall design. If your design includes casing, review the Kerf line instead and confirm the relevant installation details.
Your enquiry is the starting point. Final sizes, configuration and compatibility should be confirmed on the approved project documentation before ordering or framing.
Use the allowance specified for the selected system and configuration. Door panel size, net frame size and rough opening are different. Confirm the approved opening dimensions with Equinox Jambs and your installer.
Early measurements help coordinate framing, but the intended finished wall thickness and floor level still need to be specified. Tell the team whether each measurement describes framing, subfloor or completed finishes.
Share photographs, wall details and the existing opening dimensions before choosing a system. A trimless installation may require work to the surrounding wall; confirm the scope with your project team before ordering.
Panel width and usable clear opening are different measurements. Frame geometry, door position and hardware can affect the clear opening. Have the project professional confirm the required clear width for the intended use.
Bring your door schedule, wall details and design intent to Equinox Jambs. We can help you identify the product information needed for the next step.